Remote Programming Software (Rps); Installer Calls Rps; Rps Calls The Control Panel - Bosch ICP-EZM2 Installer's Manual

.
4.6

Remote Programming Software (RPS)

There are two methods to start a session with the remote programming software (RPS): the installer calls RPS,
or RPS calls the control panel.
Select the method that best meets the system's needs for remote programming.
RPS-to-control panel communication not investigated by UL.
At any time during a voice phone session between the installer and RPS operator, the RPS operator
can start the remote programming session by selecting Direct as the connection method and
clicking Connect on the RPS Panel Communication window.
4.6.1

Installer Calls RPS

1. From the house phone, the installer dials the RPS phone number.
2. At the site where the RPS PC is located, the RPS operator clicks Answer on the Panel Communication
window. The control panel seizes the phone line, and the remote programming session starts.
4.6.2

RPS Calls the Control Panel

RPS can use either the public switched telephone network (PSTN) or a direct connection to call the control
panel.
PSTN Option
1. The RPS operator selects Modem as the connection method in the Panel Communication window, and
then clicks Connect.
2. When the incoming call is answered, RPS sends the connection tone and the remote programming session
starts.
Direct Connection
1. Connect the RPS PC or laptop to
the control panel's house phone
terminals.
It might be necessary to connect
a 270 Ω to 330 Ω, ¼ W resistor.
2. Press and hold the control panel's
System Test button for
approximately 15 seconds, or
until the relay clicks.
3. From the RPS Panel
Communication window, select
Direct as the connection method
and click Connect. The remote
programming session starts.
4. At the end of the remote
programming session, reconnect
the PSTN line if it was
disconnected in Step 1.
Bosch Security Systems, Inc. | 5/07 | F01U025147-01
Easy Series (ICP-EZM2) | Installer Guide | 4.0 Programming
OR
15 s
55