Bosch ICP-EZM2 Installer's Manual page 66

Easy Series (ICP-EZM2) | Installer Guide | 7.0 Reference Materials
How do I delete a user?
Only the master user can delete a user.
From the control center:
1. Press and hold [3].
2. When prompted, present the master user token or enter the master user passcode.
3. Press [3] to delete a user.
4. To select the first available user (not the master user), press [1]. To select a different user, press [2].
Repeat this step until you select the desired user.
5. Press [1] to delete the user.
The system announces that the user was deleted.
The voice description is not deleted. Record a new description for a user that replaces the deleted user.
6. Repeat Steps 4 and 5 to delete more users, tokens, and key fobs, or press [5] to exit.
From a phone:
1. Start a phone session. Refer to Section 1.3 Basic Operation Information on page 4 for instructions.
2. When prompted, enter the master user passcode.
3. Press [4] to select the User Menu.
4. Follow Steps 3 to 5 above to delete users and tokens, or press [#] to exit.
To delete only a token:
1. Delete the user (follow either procedure shown above).
2. Add the user, but skip the step to assign a token or key fob.
Follow either procedure shown in "How do I add a user or token or key fob?" on page 65.
I assigned a token to User 1 (Master User). Can I delete this token?
No. Once a token is assigned to User 1, User 1 always requires a token. The token cannot be deleted.
How do I replace a user's lost token or key fob?
1. Save the user's passcode (record it elsewhere).
2. Access the User Menu from either the control center or the User Phone Menu.
Refer to Section 1.2 Control Center Overview on page 3, or Section 1.3 Basic Operation Information on page 4, for
more information.
3. Delete the user.
4. Re-enter the user (use saved passcode).
5. Add the new token or key fob.
How do I reset a fire point?
1. To silence the alarm, present your token to the control center, or enter your passcode.
2. Repeat Step 1 to reset the fire point.
This procedure applies to any fire point type, such as a smoke detector, heat detector, or pull station.
How do I configure a four-wire smoke detector?
Connect the smoke detector's power wires to any programmable output. Then select "System Reset" for the output's
function.
Can I reset an emergency alarm?
No. When an emergency alarm starts (press and hold both [1] and [2] keys on control center), the system announces an
emergency alarm message once every minute for five minutes.
Can I turn the system on if there is a malfunction, such as a loss of main power?
Yes. Present your token twice to the control center.
Why do I hear the siren beep during Entry Delay?
Graduated Annunciation (Expert Programming Item Number 148) is enabled. If this item is enabled, the outputs
periodically activate during Entry Delay to remind you to turn your system off.
Why does the siren activate during a Panic alarm?
Panic alarm is programmed for audible alarm.
In expert programming, change Expert Programming Item Number 890 from 1 (audible alarm) to 2 (silent alarm).
My history log and central station report show Point 0 and User 0. What are these?
Point 0 = on-board input for EZTS tamper switch.
User 0 = installer.
66 Bosch Security Systems, Inc. | 5/07 | F01U025147-01