5.0 System Test; 6.0 Maintenance - Bosch ICP-EZM2 Installer's Manual

Easy Series (ICP-EZM2) | Installer Guide | 5.0 System Test

5.0 System Test

When the installation and programming of the control panel is complete, test the control panel and all devices
for proper operation. Test the control panel after you first program it, and after any subsequent programming.
If you test a device and the control panel does not respond, check the device, its wiring, and any related
settings or programming for potential errors.
To conduct a full system test, use either option:
Installer Menu
1. Start a phone session. Refer to Section 1.3 Basic Operation Information on page 4 for instructions.
2. When prompted, enter the installer passcode.
3. Press [1] for System Maintenance.
4. Press [2] for Full System Test.
One-Button System Test
Press the System Test button on the control panel board once.
The system performs the same tests available on the Installer
Menu.
√ LED green flash = test successful
√ LED red flash = test unsuccessful

6.0 Maintenance

Bosch recommends testing the system regularly, and inspecting it according to local code or law.
56 Bosch Security Systems, Inc. | 5/07 | F01U025147-01