Bosch ICP-EZM2 Installer's Manual page 25

.
Key Fobs
Add key fobs after all other wireless devices (inputs and outputs) are discovered and configured.
1. After the last wireless device is configured and the Point Test ends, press [#] repeatedly until you exit the
Installer Menu and end the phone session.
2. Start a new phone session, or press and hold [3] on the control center, and enter the master user (User 1)
passcode.
3. Press [4] to select the User Menu.
4. Press [1] to add a new user.
5. Enter a passcode.
6. Re-enter the passcode.
7. Press [4] to add a key fob.
Token assignment and voice description are optional.
8. Repeat Steps 4 to 7 to add more users and key fobs, or press [#] repeatedly to end the phone session.
To create a key fob-only system (no wireless input or output devices installed), start at Step 2.
In a key fob-only system, adding the first key fob might take several minutes to complete as the wireless
network is established and configured. Subsequent key fob additions take less time.
Bosch Security Systems, Inc. | 5/07 | F01U025147-01
Easy Series (ICP-EZM2) | Installer Guide | 3.0 Point Expansion
25