Remove The Chain/Sprocket Cover Protection Casing; Throttle Cable Adjustment - Husqvarna CR 65 2012 Workshop Manual

4
2
3
1
3
4
SETTINGS AND ADJUSTMENTS
CR 65 2012
9

Remove the chain/sprocket cover protection casing

1
Cut the ties (1) and remove the casing (2).
Loosen the 3 screws (3) that fasten the sprocket cover to the LH casing (4) and
remove the protection.

Throttle cable adjustment

To check the correct adjustment of the throttle control cable, operate as fol-
lows:
- Turn throttle control twistgrip (1) and make sure it has about 2 mm free
play;
- If not so, move the rubber protection (2), loosen the ring nut (3) and work the
adjuster screw (4) (loosen to decrease play or tighten to increase it);
- After the adjustment lock the ring nut (3) and fit the rubber protection (2)
again.
2
After the adjustment, check for no rpm increase when turning the han-
dlebar to the left and to the right with engine running at idle; if this is the
case, carry out the adjustment again.
Operation with damaged throttle cable could result in an unsafe riding
condition.
Exhaust gas contains poisonous carbon monoxide. Never run the engine
indoors.
D.5
Workshop Manual Ed. 09-2011