Chain Guard Removal; Throttle Cable Adjustment - Husqvarna CR 50 / 2011 Workshop Manual

4
3
3
1
3
4
2
1
Ed. 01-09-2010
SETTINGS AND ADJUSTMENTS

Chain guard removal

Cut clips (1), and remove guard (2).
Cut clips (3), and remove sprocket guard (4).
H02026

Throttle cable adjustment

To check the correct adjustment of the throttle cable, operate as follows:
- move rubber cap (1) at cable end;
- push and pull cable (2) to make sure it has about 2 mm free play;
- if not so, loosen the lock ring nut (3) and suitably turn the adjuster screw (4)
(loosen to decrease play or tighten to increase it);
- tighten back the lock ring nut (3).
Operation with damaged throttle cable could result in an unsafe riding
condition.
Exhaust gas contains poisonous carbon monoxide. Never run the engine
H02027
indoors.
For a further adjustment, move rubber cap (6) aside, and turn carburettor screw
(5).
6
5
H02028
D.5