Configuring Link State Monitoring For Iscsi Network Interfaces - HP StoreAll Series Installation Manual

For more information about VLAN tagging, see the HP StoreAll Storage Network Best Practices
Guide.

Configuring link state monitoring for iSCSI network interfaces

NOTE: Do not configure link state monitoring for user network interfaces or VIFs that will be used
for SMB or NFS.
Link state monitoring is supported only for use with iSCSI storage network interfaces, such as those
provided with 8200/9300 Gateway systems.
To configure link state monitoring on a 8200/9300 system, use the following command:
ibrix_nic -N -h HOST -A IFNAME
To determine whether link state monitoring is enabled on an iSCSI interface, run the following
command:
ibrix_nic -l
Next, review the LINKMON column in the output. The value yes means that link state monitoring
is enabled; no means that it is not enabled.
148 Configuring virtual IP addresses