Step 2 - Designating Ip Addresses For Dns/Ntp Servers; Step 3 - Reviewing Servers Listed On The File Servers Screen And Designating Which Servers To Be Included In The Cluster - HP StoreAll Series Installation Manual

4. Click OK. The Cluster Settings screen appears again.
5. Click Next to continue to the DNS/NTP screen.

Step 2 - Designating IP addresses for DNS/NTP servers

1. On the DNS/NTP screen, enter the DNS server addresses and search for the domain that is
to be used by the cluster and the NTP server addresses. HP recommends that you enter a DNS
server address, the domain for your cluster, and then NTP server addresses.
After you make DNS/NTP screen entries, the wizard attempts to access the addresses that you
have specified. If it cannot reach an address, a message, such as Primary DNS Server
Unreachable, is displayed. See
for additional information on solutions to common problems.
2. After the addresses are successfully entered, click Next to continue. The system runs its discovery
process, and then the File Servers screen appears. This discovery process can take several
minutes.
Step 3 - Reviewing servers listed on the File Servers screen and designating
which servers to be included in the cluster
1. Review the servers listed on the File Servers screen. Select servers that do not belong in the
cluster, and click Remove.
NOTE:
the line that contains the server you are selecting.
Do not click on the HA Pair text that is blue and underlined. Click anywhere else on
"Troubleshooting the Getting Started Wizard" (page 114)
Step 2 - Designating IP addresses for DNS/NTP servers 109