20. Do one of the following:
After the Join Cluster screen appears, showing all available management consoles, select
the applicable management console, and then select Ok to complete the configuration.
Select Cancel if the applicable management console is not listed to display the
Management Console IP screen, enter the IP address of the management console, and
then select Ok.
The wizard registers and starts a passive management console on the blade.
The installation of the initial expansion blade is complete.
Installing the second expansion blade
The installation procedure for installing the second expansion blade is similar to that of the initial
node, except the firmware, chassis, SAS, and storage checks are already in place.
220 Expanding an existing HP StoreAll Storage system using the Setup Wizard