Configuring The Chassis On The Hp Storeall 9730 Storage System - HP StoreAll Series Installation Manual

10. On the Enclosure Settings screen, select Standby OA or OA2, and press OK.
1 1. On the Network Settings:OA2 screen, navigate to Active IPv4, and press OK.
12. Set the IP address, subnet mask, and gateway (optional), and accept the changes.
13. Go back to the Network Settings:OA2 screen, navigate to Accept All, and press OK.
The Main Menu reappears and the procedure is complete.

Configuring the chassis on the HP StoreAll 9730 Storage system

This portion of the HP StoreAll OS Software installation process is completed using a wizard
application and involves completing network configurations. The configuration process, which uses
the X9730 Setup Wizard, involves:
Setting the system name
Setting the system date and time
Configuring the network
Entering a gateway IP address
Confirming and then committing to, configuration entries
Advanced network configuration options are also available when you use the wizard.
NOTE: At any time during this process, select Cancel or Quit (if available) to exit the application
or Back (if available) to go back to the previous screen. On applicable screens, press F1 to display
on-screen help information.
Use the Space bar and Tab key to move between screen options or move to available screen
buttons, such as Cancel, Ok, Back, and so forth.
If the screen goes into screen save mode, press the arrow key on the keyboard.
Before beginning this procedure, complete the instructions in
installing the HP StoreAll OS Software" (page
To start the X9730 Setup Wizard:
"Creating a bootable device and
51).
Configuring the HP StoreAll 9730 Storage systems 79