Creating A Cluster Using Ascii Mode On Blade 1 On The Hp Storeall 9730 Storage System - HP StoreAll Series Installation Manual

IMPORTANT:
Network Bond0 was configured without errors.
Broadcast is enabled. The web UI relies on broadcast network traffic.
Broadcast or multicast functions are operational.
You entered a gateway IP address on the Server Setup screen.
If your cluster does not meet these conditions, you must press F2 from the X9000 Installation
- Network Setup Complete screen to complete cluster networking in ASCII mode. See
a cluster using ASCII mode on blade 1 on the HP StoreAll 9730 Storage system" (page 93)
for related procedures to complete the installation.
NOTE:
one of the cluster options from the X9000 Installation - Network Setup Complete screen options,
you will then be required to complete applicable follow-on steps to complete the installation
process.
If you select Join this StoreAll server to an existing cluster, continue to
HP StoreAll 9730 Storage system blades" (page
a message appears instructing you to go to Fusion Manager to complete the installation
process.
If you select Continue with cluster setup at this console (Local web UI session) or Continue
with cluster setup at this console (Remote web UI session), after a message stating that
the management console is to connect to the server is displayed, continue to
clusters remotely with the Getting Started Wizard" (page 105)
on the subsequent HP StoreAll Management Console screen.
NOTE:
Continue with cluster setup at this console (Local web UI session), after the message stating
that the management console GUI is to be launched is displayed and a web page is
automatically opened, another message may display stating that the connection is an
untrusted one. If this occurs, select Add Exception, and then select Confirm Security
Exception. The login screen for the HP StoreAll Management Console appears afterwards.
This exception typically occurs with the Mozilla Firefox browser software application..
If you select Exit Now (You just wanted to setup networking) in
configuring a subsequent server, rather than the initial server, the system is ready to be
added to the cluster. If you select this option as part of the installation of the initial server
in the installation, to complete the entire installation process, you must join the blade to
a cluster (see the Join this StoreAll server to an existing cluster option).
20. Determine whether there are any HP StoreAll OS Software maintenance releases later than
the current HP StoreAll OS Software version (see
Software version information" (page
necessary files and follow provided maintenance release instructions.
Creating a cluster using ASCII mode on blade 1 on the HP StoreAll 9730 Storage
system
Use the following instructions if on the initial node you pressed F2 for ASCII mode in
"Configuring the chassis on the HP StoreAll 9730 Storage system" (page
To create the cluster on blade 1:
To use the web UI, your cluster network must meet the following conditions:
After you complete this step on the initial server in your storage system and select
If you opt to continue using the console from which you are working by selecting
95). During a remote console session,
"Factory default and current HP StoreAll OS
7)). If maintenance releases are available, acquire
Configuring the HP StoreAll 9730 Storage systems
"Creating
"Installing additional
"Configuring
and enter login credentials
Step 19 and you are
Step 19 of
79).
93