HP StoreAll Series Installation Manual page 218

Powers off blades 2- 1 6, applies the SAS configuration, and then reboots blade 1.
Log in to blade 1 when the Linux login prompt appears.
After the reboot, the wizard takes the following actions:
◦
◦
◦
◦
Forms Bond0 from eth0 and eth3.
19. The X9000 Installation - Network Setup Complete screen appears. Select Join this StoreAll
server to an existing cluster.
218 Expanding an existing HP StoreAll Storage system using the Setup Wizard
Verifies the SAS configuration to ensure that SAS zoning is set up correctly
Powers on blades 2- 1 6
Verifies storage firmware to ensure that it is set up correctly
Validates the LUN layout and configures it, if necessary