Create A Default File System Screen - HP StoreAll Series Installation Manual

Table of Contents

# ethtool eth5 | grep -i speed

Speed: 10000Mb/s

◦

If the speed of the NIC ports selected for bond creation is 10 GB, use any two NIC ports

in bond Mode 1.

◦

If the speed of the NIC ports selected for bond creation is 1 GB, use four NIC ports in

bond Mode 6.

NOTE:

9730 Storage system; however, the difference between the two systems is the speed

shown. What is shown depends on the Virtual Connect configuration for HP StoreAll

9730 Storage system. See

information.

If these steps do not resolve the condition, use the text-based installation method to form the

cluster.

Adding or configuring a server fails with an error message that the IP address or host name

is already in use

Probable causes:

If you are recovering a server, you cannot use the Getting Started Wizard to join the server

to the cluster. On the File Servers screen, the Configure and Remove buttons are disabled. If

you attempt to add the server, and enter its IP address, the following error message is displayed:

<IP address> cannot be used to join that server to this cluster

because its IP address is already in use. If you are trying to

restore it, please use the local console.

Further, if you select a discovered server and attempt to add the recovered server's IP address

or host name to it, a similar message is displayed:

<Host name> cannot be used to join that server to this cluster

because its <host name> host name is already in use. If you are

trying to restore it, please use the local console.

Troubleshooting steps:

Exit the Getting Started Wizard.

Use the local console (ASCII GUI Configuration wizard) to join the recovered server to the

cluster. See the procedure for recovering a node in the Administrator Guide for your platform.