HP StoreAll Series Installation Manual page 29

example, port 1 in slot 2 on each StoreAll node connects to switch 1 and port 2 in slot 2 on
each StoreAll node connects to switch 2. Also, port FC- 1 in node 0 of each 3PAR storage
connects to switch 1 and port FC-2 in node 1 of each 3PAR storage connects to switch 2.
(Switches are named 1 and 2 for example purposes only.)
If cabling an HP StoreAll 8200 Gateway system that uses multiple controllers and an HP 3PAR
StoreServ 7000-series controller without FC switches, connect each server FC HBA to a different
controller to ensure no single point of failure, hardware redundancy, and multipath capability.
If cabling an HP StoreAll 8200 Gateway system that uses multiple controllers and an HP 3PAR
StoreServ 7000-series controller with FC switch connectivity to application servers, connect
each server FC HBA to a different switch, and connect each HP 3PAR StoreServ 7000-series
controller to a different switch to ensure no single point of failure within the configuration,
hardware redundancy, and multi-path capability.
When cabling the HP 3PAR StoreServ 10000-series controllers to HP StoreAll 8200 Gateway
systems, note that three internal buses exist in each controller node. See the adapter installation
requirements in Table 1 1 (page 29)
Table 1 1 PCI Bus/PCI slot association
PCI 1
SLOT 0 SLOT 1 SLOT 2
Table 12 Adapter installation order and usage based on controller node type
Usage (adapter type)
Drive chassis connections
(Fibre Channel adapters)
Hosts connections
(Fibre Channel adapters)
RCFC connections
Remote Copy
(RCIP ports built-in)
See the HP 3PAR StoreServ 10000 Storage Installation and Deinstallation Guide for additional
information on HP StoreAll 8200 and 8800 Storage system connection information and related
HP 3PAR StoreServ device information.
and Table 12 (page
PCI 2
SLOT 3 SLOT 4 SLOT 5
Installation order by PCI slot
6, 3, 0
2, 5, 8, 1, 4, 7
1, 4, 2, 3
E1
Cabling HP StoreAll Storage system components
29).
PCI 3
SLOT 6 SLOT 7 SLOT 8
29