Completing The Installation From The Getting Started Wizard - HP StoreAll Series Installation Manual

After selecting Ok, the Add Bond Interface screen appears.
15. On the Add Bond Interface screen, provide the bond name, VLAN Tag ID, IP address, netmask,
and gateway ID, and then select Ok to save entries.
16. On the X9000 Installation Complete - Network Setup screen, select one of the following
options, to complete the installation:
Use the Getting Started Wizard only if the original 93xx cluster was configured with HP
StoreAll by using the wizard. The cluster must use the flat network. Select either Continue
with cluster setup on this console (Local web UI session) or Continue with cluster setup
remotely (Remote web UI session) and then go to
Getting Started Wizard" (page 236)
Continue with the installation wizard for all other expansions as it allows the network on
the new server to be configured to match the existing cluster. See
installation with the ASCII text wizard" (page

Completing the installation from the Getting Started Wizard

If you selected Continue with cluster setup at this console (local web UI session) or Continue with
cluster setup remotely (remote web UI session) in
Complete screen of the ASCII text wizard, exit the wizard, and complete the following steps:
NOTE: At any time during this procedure, you may click Back (if available) to go to the previous
screen, Next (if available) to go to save entries and then the next screen, or Cancel to exit the
installation procedure. You may also click Help to display on-screen help information.
236 Expanding an existing HP StoreAll Storage system using the Setup Wizard
"Completing the installation from the
to complete remaining steps.
238).
Step 16 of the X9000 Installation - Network Setup
"Completing the