Table of Contents
Advertisement
Figure 4: Topology diagram - advanced network configuration, management connections
1
Host/server
2 Management network
Dual Fabric Fibre Channel
In this configuration, two Fibre Channel ports on a host HBA are connected to two separate Fibre Channel switches, with each
Fibre Channel switch connected to both controllers on the array. The host management port and the controller management
ports are connected through an Ethernet switch.
This configuration provides redundant paths for Fibre Channel traffic. If one of the host Fibre Channel ports fails, or one of
the Fibre Channel switches fails, the host remains connected to both controllers through the remaining host Fibre Channel
port or Fibre Channel switch, and Fibre Channel traffic continues uninterrupted.
Note that only one data connection is shown. You can add more connections and use different ports as needed.
IP Addresses
An IP address is a 32-bit identifier for devices on a TCP/IP network. IP addresses allow devices on a network, such as servers,
switches, and arrays, to communicate with each other. HPE storage arrays use IP addresses for the following purposes:
Table 1: Types of IP addresses
IP Address
Purpose
Management
Typically defined on eth1 or on eth1 and eth2 interface, the management IP address provides access
to the management interface (GUI, CLI, or API) for the array group. It is also used for volume replication.
It resides on the group management subnet and floats across all management only (Mgmt only) and
management + data (Mgmt + Data) interfaces.
Documentation Feedback: doc-feedback-hpe-storage@hpe.com
3
Array
Install the HPE Storage Array 13
Advertisement
Table of Contents
