Replacing The Oil Filter - Yamaha F30A Service Manual

CHK
ADJ
3. Place a drain pan under the drain hole,
and then remove the engine oil drain bolt
2 and let the oil drain completely.
2
NOTE:
• Be sure to clean up any oil spills.
• When using an oil changer to change the
engine oil, insert the oil changer hose into
the oil dipstick hole.
4. Install the engine oil drain bolt 2, and
then tighten it to the specified torque.
Engine oil drain bolt 2:
17 N·m (1.7 kgf·m, 12.5 ft·lb)
5. Pour the specified amount of the recom-
mended engine oil into the oil filler hole.
Recommended engine oil:
4-stroke motor oil
API: SE, SF, SG, SH, SJ, or SL
SAE: 5W-30, 10W-30, or 10W-40
Engine oil quantity:
Without oil filter replacement:
2.0 L (2.11 US qt, 1.76 Imp qt)
6. Install the oil filler cap and oil dipstick,
and then start the engine and warm it up.
7. Turn the engine off, and then check the
oil level and that there is no oil leakage. If
the oil level is low, add engine oil to the
correct level.

Replacing the oil filter

1. Drain the engine oil or use an oil changer
to extract it.
3-5
Periodic check and adjustment
S67C3009
2. Place a rag under the oil filter, and then
remove the oil filter using a 64 mm (2.5
in) oil filter wrench 1.
NOTE:
• Wait more than 5 minutes after turning the
engine off to replace the oil filter.
• Be sure to clean up any oil spills.
Oil filter wrench 1: 90890-01426
3. Apply a thin coat of engine oil to the O-
ring of the new oil filter.
4. Install the oil filter, and then tighten it to
the specified torque using a 64 mm (2.5
in) oil filter wrench 1.
E
Oil filter:
18 N·m (1.8 kgf·m, 13.3 ft·lb)
5. Pour the specified amount of the recom-
mended engine oil into the oil filler hole.
1
S67C3010
1
S67C3011
67C3K11