BRKT
Disassembling the tilt cylinder
1. Hold the power trim and tilt 1 in a vise
using aluminum plates a on both sides.
2. Loosen the tilt cylinder end screw 2, and
then remove it.
WARNING
Make sure that the ram is fully extended
before removing the end screw.
Cylinder-end screw wrench:
90890-06544
3. Drain the fluid.
Disassembling the trim cylinder
1. Hold the trim cylinder 1 in a vise using
aluminum plates a on both sides.
7-35
Bracket unit
NOTE:
Place the trim cylinder in the vise horizon-
tally.
2. Loosen the trim cylinder end screw 2,
and then remove it.
CAUTION:
Do not damage the check valve b when
loosening the end screw.
Cylinder-end screw wrench:
90890-06544
Disassembling the gear pump
1. Remove the manual valve 1 and gear
pump 2.
2. Remove the relief valve bracket 3, then
the down-relief valve 4 and up-relief
valve 5.
62Y5A11