Call Transfer Music Or Ringing Option; Call Transfer Recall; Centrex/Pbx Features; Conferencing - Toshiba Strata DK14 General Description Manual

Features
Station Features

Call Transfer Music or Ringing Option

This feature enables ringing or music to be heard by the caller when a call is transferred,
depending on system programming. Prior to Release 3.2, callers heard music during the transfer
process and no ringing option in programming was available.

Call Transfer Recall

CO, DID, or Tie lines that are transferred (internally or over Tie lines) will recall to the transferring
station if the called station does not answer. The recall time is individually set for each transferring
station.

Centrex/PBX Features

System Speed Dial buttons can be programmed with access codes, plus any flashes or pauses
necessary to access features through a host switching system.

Conferencing

A variety of Conferencing combinations are available to all station users, as listed below. Stations
and lines can be added in any order. (See
information.)
One or two stations and two outside lines
Two or three stations and one outside line
Four stations on one internal [DN] line
Three to four simultaneous Conference calls
Voice Mail plus one station and two other parties (internal or outside line for DK424, Release
3.2 and above. (Outside line must be analog, not digital.)

Continuous Dual-tone Multi-frequency (DTMF) Tone

The DTMF dial signal sent to an outside line or voice mail/auto attendant device can continue as
long a DKT2000-series digital telephone user presses a button on the dial pad. This feature is not
available with electronic or DKT1000-series digital telephones.

Data Call Button

A flexible button on a digital telephone can be assigned as a
to dial internal data calls. The telephone must be equipped with an RPCI-DI for
applications.

Direct Station Selection (DSS) Buttons

Digital telephone users can ring selected stations by pressing a flexible feature button assigned for
a DSS function. The LED associated with the button provides the busy status of the station and the
station's [PDN]. Each flexible button can be assigned as a DSS button to a different station [PDN].
DSS buttons can also be assigned on DADMs.

Direct Station Selection (DSS) Console Features

On DK40i and DK424, digital and electronic telephones can operate with DSS consoles, which
offer the following features:
Automatic CO line Hold
94
"Amplified Conference Interface"
(Table 32 on Page
'DWD &DOO
on Page 62 for more
88).
button, which can be used
'DWD &DOO
button
Strata DK General Description 5/99