Vfo-A Receiver - Yaesu FT DX 3000 Operating Manual

i
nTerFerence
p.bAcK ( A
When Audio Playback is engaged by the operator, the FT
incoming receiver audio on VFO-A. Recording is controlled with the supplied FH-2 Remote Control Keypad, plugged
into the rear panel REMOTE jack. This capability is especially useful for confirming a callsign that may have been
difficult to copy due to noise or QRM, etc.
Recording
r Press and hold in the FH-2 [ P/B ] key for two
seconds to initiate recording. The "REC" icon will
appear in the display to confirm that recording is in
progress.
r Press the FH-2 [ P/B ] key briefly to halt recording;
the "REC" icon will go out.
Page 44
r
ejecTiOn
)
p
udio lAybAcK FRoM
3000 begins automatically recording the last 15 seconds of
DX
Playback
r Press the FH-2 [ P/B ] key briefly, after recording
r To halt playback at any time, just press the [ P/B ]
A
You may adjust the playback level of the recording with
the main [ AF ] knob.
vFo-A R
eceiveR
has been halted, to begin playback of the recorded
audio; the "PLAY" icon will appear in the display
to confirm that playback is in progress. The last 15
seconds of audio will be heard in the speaker or
headphones. If you do not intervene, the entire 15
seconds will be played back, repeating endlessly.
key briefly again. The next time you press the [ P/B ]
key, it will pick up the playback where you left off.
:
dvice
Stop
Start
15 Seconds
FT 3000 O
DX
M
peraTing anual