Data Mode; Psk Tone; Cw Wave Shape; Cw Freq Display - Yaesu FT DX 3000 Operating Manual

M M
enu ODe
061 CW BK-IN
Function: Sets the CW "break-in" mode.
Available Values: SEMI/FULL
Default Setting: SEMI
SEMI: The transceiver will operate in the semi break-in
mode. The delay (receiver recovery) time is set
via the Menu item "062 CW BK-IN DELAY".
FULL: The transceiver will operate in the full break-in
(QSK) mode.
062 CW BK-IN DELAY
Function: Adjusts the Keying Delay (receiver recovery)
time on the CW mode.
Available Values: 30 ~ 3000 msec (10 msec/step)
Default Setting: 200 msec

063 CW WAVE SHAPE

Function: Selects the CW carrier wave-form shape (rise/
fall times).
Available Values: 1/2/4/6 msec
Default Setting: 4 msec

064 CW FREQ DISPLAY

Function: Selects the frequency Display Format for the
CW mode.
Available Values: DIRECT FREQ/PITCH OFFSET
Default Setting: PITCH OFFSET
DIRECT FREQ: D i s p l a y s t h e r e c e i v e r c a r r i e r
frequency, without any offset added.
When changing modes between
SSB and CW, the frequency display
remains constant.
PITCH OFFSET: This frequency display reflects the
added BFO offset.
065 PC KEYING
Function: Enables/disables CW keying from the USB
jack on the rear panel, while operating on the CW mode.
Available Values: OFF/DTR/RTS
Default Setting: OFF
066 QSK
Function: Selects the time delay between when the
PTT is keyed and the carrier is transmitted during QSK
operation when using the internal keyer.
Available Values: 15/20/25/30 msec
Default Setting: 15 msec
Page 118
MODE-DATA Group

067 DATA MODE

Function: Selects the operation mode of the DATA
mode.
Available Values: PSK/OTHER
Default Setting: PSK

068 PSK TONE

Function: Selects the PSK tone frequency.
Available Values: 1000/1500/2000 Hz
Default Setting: 1000 Hz
069 OTHER DISP (SSB)
Function: Sets the packet frequency display offset.
Available Values: -3000 ~ 0 ~ +3000 Hz (10 Hz/step)
Default: 0 Hz
070 OTHER SHIFT (SSB)
Function: Sets the carrier point during the SSB packet
operation.
Available Values: -3000 ~ 0 ~ +3000 Hz (10 Hz/step)
Default: 1000 Hz (typical center frequency for PSK31,
etc.)
071 DATA LCUT FREQ
Function: Selects the cutoff frequency of the lower side
of the RX audio filter in the DATA mode.
Available Values: OFF/100 ~ 1000 Hz (50 Hz/step)
Default Setting: 300
072 DATA LCUT SLOPE
Function: Selects the filter slope of the lower side of the
RX audio filter in the DATA mode.
Available Values: 6dB/oct / 18dB/oct
Default Setting: 18dB/oct
073 DATA HCUT FREQ
Function: Selects the cutoff frequency of the upper side
of the RX audio filter in the DATA mode.
Available Values: OFF/700 ~ 4000 Hz (50 Hz/step)
Default Setting: 300

074 DATA HCUT SLOPE

Function: Selects the filter slope of the upper side of the
RX audio filter in the DATA mode.
Available Values: 6dB/oct / 18dB/oct
Default Setting: 18dB/oct
FT 3000 O
DX
M
peraTing anual