Full Break-In (Qsk) Operation; Setting The Keyer Weight (Dot/Dash) Ratio - Yaesu FT DX 3000 Operating Manual

cW M
ODe
As shipped from the factory, the FT
However, this setup may be changed to full break-in (QSK) operation using Menu item "061 CW BK-IN". With
full break-in QSK, the TX/RX switching is quick enough to hear incoming signals in the spaces between the dots
and dashes of your transmission.
1. Press the [ MENU ] button to engage the Menu.
2. Rotate the [ SELECT ] knob (or press the p/q
button) to select Menu item "061 CW BK-IN".
3. Press the [ SELECT ] button, then rotate the
[ CLAR/VFO-B ] knob (or press the p/q button)
to set this Menu item to "FULL".
4. When your adjustments are complete, press the
[ SELECT ] button, then press the [ MENU ] but-
ton to save the new setting and exit to normal
operation.
A number of interesting and useful features are available during Electronic Keyer operation.
This Menu item may be used to adjust the dot/dash ratio for the built-in Electronic Keyer. The default weighting
is 3:1 (a dash is three times longer than a dot).
1. Press the [ MENU ] button to engage the Menu.
2. Rotate the [ SELECT ] knob (or press the p/q
button) to select Menu item "022 CW WEIGHT".
3. Press the [SELECT] button, then rotate the
[CLAR/VFO-B] knob (or press the p/q button)
to set the weight to the desired value. The avail-
able adjustment range is a Dot/Dash ratio of 2.5
~ 4.5 (default value: 3.0).
4. When you are finished, press the [ SELECT ] but-
ton, then press the [ MENU ] button to save the
new setting and exit to normal operation.
Page 78
O
peraTiOn
U b -
sing The UilT

Full Break-in (QSK) Operation

3000 TX/RX system for CW is configured for "Semi-break-in" operation.
DX

Setting the Keyer Weight (Dot/Dash) Ratio

e k
in lecTrOnic eyer
[ SELECT ] Button
[ MENU ] Button
[ SELECT ] Button
[ MENU ] Button
FT
DX
[ CLAR/VFO-B ] Knob
[ CLAR/VFO-B ] Knob
3000 O M
peraTing anual