Memory Scan - Yaesu FT DX 3000 Operating Manual

Hf/50 mhz transceiver
Hide thumbs Also See for FT DX 3000:
Table of Contents

Advertisement

1. Set the transceiver up in the "Memory" mode by
pressing the [ V/M ] button, if necessary.
a
:
dviCe
If you can not enter the "Memory" mode, check to
see if the transceiver is in VFO-B mode (the green
[ VFO-B ( RX )] Indicator/Switch is illuminated). If so,
press the [ VFO-A ( RX )] Indicator/Switch to return
operation to VFO-A. Now, press the [ V/M ] button to
enter the "Memory" mode.
2. Rotate the [ RF/SQL ] knob so that the background
noise is just silenced.
3. Press and hold in the microphone [ UP ] or [ DWN ]
key for one second to start scanning in the specified
direction.
a
:
dviCe
 If the scanner halts on an incoming signal, the
decimal point between the "MHz" and "kHz"
digits of the frequency display will blink.
 If the incoming signal disappears, scanning will
resume in about five seconds.
4. To cancel scanning, press the [ PTT ] witch.
a
:
dviCe
 During Memory Group operation, only the channels
within the current Memory Group will be scanned.
 If the scan has paused on a signal, pressing the mi-
crophone [ UP ] or [ DWN ] key will cause scanning to
resume instantly.
 If you press the microphone PTT switch during
scanning, the scanner will halt at once. However,
pressing the PTT switch during scanning will not
cause transmission.
 You may select the manner in which the scanner re-
sumes while it has paused on a signal, using Menu
item "046 MIC SCAN RESUME". During memory
scanning, the default "TIME" (5 sec) setting will
cause the scanner to resume scanning after five
seconds. However, you may change this setting to
resume only after the carrier has dropped out, if you
like.
FT
3000 O
DX
peraTing
VFO
anD
M
eMory
M
anual
M
eMOry
s
Can
[ VFO-A ( RX )] Button
[ RF/SQL ] Knob
Q
P
:
uiCk
oint
If you have no interest in scanning, and wish to prohibit
the microphone [ UP ] / [ DWN ] keys from initiating scan-
ning, you may disable scanning control from the mi-
crophone using Menu item "046 MIC SCAN" (set it to
"DISABLE").
s
canning
[ VFO-B ( RX )] Button
[ V/M ] Button
Page 101

Advertisement

Table of Contents
loading

Table of Contents