Yaesu FT DX 3000 Operating Manual page 24

F p
rOnT anel
[( VFO-B ) RX ] Indicator/Switch
This button switches the receiving frequency to
VFO-B, the green LED imbedded within the but-
ton will light. When the transceiver is receiving the
VFO-B frequency, pressing this button momentarily
will mute the receiver and the indicator will blink.
Pressing the button once more will restore receiver
operation, and the indicator will glow green steadily.
[( VFO-B ) TX ] Indicator/Switch
This button transfers control of the transmit fre-
quency/mode to VFO-B, and the red LED in the but-
ton will light. Pressing this button again will transfer
frequency/mode control back to the VFO-A side, and
the red LED imbedded within this button will turn
off.
[ C.S ] Switch
Press this button momentarily to directly recall a fa-
vorite Menu Selection.
To program a Menu selection to the [ C.S ] button,
press the [ MENU ] button to enter the Menu. Select
the Menu item you want to set as the short cut. Press
the [ C.S ] button, then press the [ MENU ] button; this
will lock in the selected Menu item as the short cut.
Page 22
C
OnTrOls
& s
wiTChes
Main Tuning Dial Knob
This large knob adjusts the operating frequency of
VFO-A. Clockwise rotation of this knob increases
the frequency. Default tuning increments are 10 Hz
(CW, SSB), 50 Hz (RTTY/DATA), 100 Hz (AM/
FM). When the [ FAST ] button is pressed, the tuning
steps increases. The available steps are:
A :
dvice
The tuning steps for the Main Tuning Dial knob
are set, at the factory, to: 10 Hz (SSB, CW), 50 Hz
(RTTY/DATA) and 100 Hz (AM/FM) per step. Via
Menu item "151 CW DIAL STEP" to "155 SSB
DIAL STEP", however, you may change these settings
to 1 or 5 Hz (SSB, CW), 1 or 10 Hz (RTTY, DATA),
and 10 Hz (AM, FM) instead.
[ FAST ] Switch
Pressing this button will change the tuning of the
Main Tuning Dial knob (VFO-A) to a higher step
rate.
When this function is activated, "FAST" appears in
the frequency display.
o m 1 S
perAtiNg ode
10 Hz ( 100 Hz )
LSB/USB/CW
100 Hz ( 1 kHz )
AM/FM
5 Hz ( 100 Hz )
RTTY/DATA
Numbers in parentheses indicate steps when the [ FAST ] button is On.
F T 30 00 O
DX
1 d r
tep iAl otAtioN
10 kHz ( 100 kHz )
100 kHz ( 1 MHz )
5 kHz (100 kHz)
M
peraTing anual