Dvs Group - Yaesu FT DX 3000 Operating Manual

M M
enu ODe

DVS Group

015 RX OUT LEVEL
Function: Sets the audio output level from the optional
DVS-6 Voice Memory Unit.
Available Values: 0 ~ 100
Default: 50
Advice:
If the optional DVS-6 Voice Memory Unit is not
connected, this adjustment has no effect.
016 TX OUT LVL
Function: Sets the microphone input level to the optional
DVS-6 Voice Memory Unit
Available Values: 0 ~ 100
Default: 50
Advice:
If the optional DVS-6 Voice Memory Unit is not
connected, this adjustment has no effect.
KEYER Group
017 F KEYER TYPE
Function: Selects the desired keyer operation mode for
the device connected to the front panel KEY jack.
Available Values: OFF/BUG/ELEKEY/ACS
Default Setting: ELEKEY
OFF: Disables the front panel keyer ("straight
key" mode for use with external keyer or
computer-driven keying interface).
BUG: Mechanical "bug" keyer emulation. One
paddle produces "dits" automatically, while
the other paddle manually produces "dahs".
ELEKEY: Iambic keyer with ACS (Automatic Character
Spacing) disabled.
ACS: Iambic keyer with ACS (Automatic Character
Spacing) enabled.
018 F CW KEYER
Function: Selects the keyer paddle wiring configuration
for the KEY jack on the front panel.
Available Values: NOR/REV
Default Setting: NOR
NOR: Tip = Dot, Ring = Dash, Shaft = Ground
REV: Tip = Dash, Ring = Dot, Shaft = Ground
Page 114
019 A1A R-TYPE
Function: Selects the desired keyer operation mode for
the device connected to the rear panel KEY jack.
Available Values: OFF/BUG/ELEKEY/ACS
Default Setting: ELEKEY
OFF: Disables the rear panel keyer ("straight
key" mode for use with external keyer or
computer-driven keying interface).
BUG: Mechanical "bug" keyer emulation. One
paddle produces "dits" automatically, while
the other paddle manually produces "dahs".
ELEKEY: Iambic keyer with ACS (Automatic Character
Spacing) disabled.
ACS: Iambic keyer with ACS (Automatic Character
Spacing) enabled.
020 R CW KEYER
Function: Selects the keyer paddle wiring configuration
for the KEY jack on the rear panel.
Available Values: NOR/REV
Default Setting: NOR
NOR: Tip = Dot, Ring = Dash, Shaft = Ground
REV: Tip = Dash, Ring = Dot, Shaft = Ground
021 ELEKEY TYPE
Function: Selects the operation mode of the internal
keyer.
Available Values: ELEKEY-A/ELEKEY-B
Default Setting: ELEKEY-B
022 CW WEIGHT
Function: Sets the Dot:Dash ratio for the built-in
electronic keyer.
Available Values: (1:) 2.5 ~ 4.5
Default Setting: 3.0
023 BEACON TIME
Function: Sets the interval time between repeats of the
beacon message.
Available Values: OFF/1 ~ 240 sec (1 sec/step)/270 ~
690 sec (30 sec/step)
Default Setting: OFF
FT 3000 O
DX
M
peraTing anual