Yaesu FT DX 9000 Series Operation Manual

When operating on an Amateur Band the Main (VFO-A) register, it is possible to use the BAND/MHz switch (#
engage the use of the CLAR/VFO-B knob (#
select several Amateur bands, and make only those bands available for selection via the CLAR/VFO-B tuning knob.
This feature can be very useful in a contest, where the 10/18/24 MHz band are not used, or if you do not have antennas for
some bands.
"My Bands" Setup
1. Press the MNU key to engage the Menu mode; the
Menu list will appear on the TFT.
2. Rotate the MAIN tuning dial (#
item TUNING 135 MY BAND.
3. Rotate the CLAR/VFO-B knob (#
band that you wish to skip (omit) from the band-se-
lection loop (when using the CLAR/VFO-B tuning
knob for band selection). The available choices are
1.8/3.5/7/10/14/18/21/24/28/50/GEN/TRV, and the
factory-default selection is TRV (only).
4. Press the ENT key to set the omission command to
ON.
5. Repeat steps 3 and 4 to select/deselect as many bands
as you like.
Note
The "ON" command sets the selected band to be skipped, while
the "OFF" command sets the selected
the band-selection list.
6. Press and hold in the MNU key for two seconds to
lock in the new configuration and exit to normal op-
eration.
"My Bands" Operation
1. Press the BAND/MHz switch (#
ded LED will glow Red.
2. Rotate the CLAR/VFO-B knob to choose the Ama-
teur band on which you wish to operate. Only those
Amateur bands that have not been skipped will ap-
pear as you scroll through the bands.
1.8MHz
3.5
7 MHz
10 MHz
14 MHz
18 MHz
21 MHz
24 MHz
28 MHz
50 MHz
TRV
GEN
FT 9000D O
DX PERATION
"MY B
ANDS
) for Amateur band selection. The "My Bands" feature allows you to
) to select Menu
) to choose a
band to be included in
); the imbed-
MHz
3.5 MHz
7 MHz
14 MHz
21 MHz
28 MHz
M
ANUAL
C
ONVENIENT
" O
PERATION
14MHz
7MHz
3.5MHz
«
F
EATURES
MNU key
MAIN tuning dial knob
CLAR/VFO-B knob
BAND/MHz knob
CLAR/VFO-B knob
21MHz
28MHz
Page 53
) to
ENT key