Rtty Text Memory; Example Of Connecting Rtty; Communications Device - Yaesu FT DX 3000 Operating Manual

rTTy ( r
Phrases (up to 50 characters) frequently used in RTTY transmission can be memorized by connecting the supplied "FH-
2" Remote Control Keypad to the rear panel REM jack. 5 channels can be memorized, and memorized content can be
transmitted by operations on the FH-2.
t M P
ext essage rograMMing
1. Press the [ MODE ] button to set the operating mode
to RTTY.
2. Press the FH-2 [ MEM ] key. A blinking "REC" icon
will appear in the display.
3. Press an FH-2 [ 1 ] ~ [ 5 ] key to select the desired
RTTY Text Memory Register into which you wish to
program the text, the blinking "REC" icon will dis-
appear.
4. Use the FH-2 [ t ] and [  ] keys to set the cursor po-
sition and use the FH-2 [ p ] and [ q ] keys to choose
the letter/number to be programmed in each slot of
the memory.
a :
dviCe
You may also use the [ CLAR/VFO-B ] knob to pro-
gram the message characters.
5. When the message is complete, add the " " character
at the end to signify the termination of the message.
6. Press and hold in the FH-2 [ MEM ] key for one sec-
ond to exit, once all characters (including " ") have
been programmed.
e
xaMPle of
Connect the RTTY communications TU (Terminal Unit) to the rear panel RTTY/PKT terminal. Be sure to read the in-
structions manual of the device to connect when connecting.
a :
dviCe
You can adjust RTTY data output level using Menu item
"096 RTTY OUT LEVEL".
FT 3000 O
DX peraTing
aDiO
rtty t
ext
C rtty C
onneCting
M
anual
) O
T
eleType
M
eMory
o -t -a rtty t
n he ir ext
Press the FH-2 [ 1 ] ~ [ 5 ] key, depending on which RTTY
Text Memory Register message you wish to transmit.
The programmed message will be transmitted on the air.
S
PO
RTTY TEXT
C Q C Q C Q D E W  D C X
RTTY TEXT
oMMuniCations
peraTiOn
M P
essage layBaCk
dB
W
d
eviCe
Page 105