Main (Vfo-A) Receiver - Yaesu FTdx5000 Series Operating Manual

P.BACK A
When Audio Playback is engaged by the operator, the FT 5000 begins automatically recording the last 15 seconds of
incoming receiver audio on VFO-A. Recording is controlled with the supplied FH-2 Remote Control Keypad, plugged into
the rear panel REMOTE jack. This capability is especially useful for confirming a callsign that may have been difficult to
copy due to noise or QRM, etc.
Recording
Press and hold in the FH-2's [ P/B ] key for two sec-
onds to initiate recording. The "
pear in the display to confirm that recording is in
progress.
Press the FH-2's [ P/B ] key briefly to halt recording;
the " " icon will go out.
ON
Start
15 Seconds
FT 5000 O
DX
P
UDIO LAYBACK FROM
" icon will ap-
LOCK
OFF
Stop
M
C
M VFO-A R
AIN
Playback
Press the FH-2's [ P/B ] key briefly, after recording has
been halted, to begin playback of the recorded audio;
the " " icon will appear in the display to confirm
that playback is in progress. The last 15 seconds of
audio will be heard in the speaker or headphones. If
you do not intervene, the entire 15 seconds will be
played back, repeating endlessly.
To halt playback at any time, just press the [ P/B ] key
briefly again. The next time you press the [ P/B ] key, it
will pick up the playback where you left off.
A
You may adjust the playback level of the recording with
the main [ AF GAIN ] knob.
F
ECEIVER
Page 45