Yaesu FT DX 3000 Operating Manual page 43

FIX mode
1. Switch the operation mode to "FIX mode".
See "Switching Between CENTER/FIX Modes" on
the previous page.
2. Press the [ SCOPE ] button momentarily to display
the scope.
 The frequency set in Menu Mode is displayed at
the leftmost start point on the screen.
 Width of scope display can be set in Menu Mode
by individual band (See below).
Frequency
1.8MHz
3.5MHz
5MHz
7MHz
10MHz
14MHz
18MHz
21MHz
24MHz
28MHz
50MHz
The FT 3000 can memorize the scope screen in up to 10 channels, and recall it later.
DX
How to memorize
Press and hold the [ SELECT ] button for one sec-
ond to memorize the current scope screen. Up to 10
channels may be memorized. Once all 10 memories
have data in them, previous data (starting with chan-
nel "1") will be over-written, on a first-in, first-out
basis.
Recalling memorized screens
1. Press the [ SCOPE ] button several times until the
"Scope Memory" screen appears.
The last stored scope screen memory will be dis-
played.
Press the [ SCOPE ] button to display the screens
in the following order:
[ MENU ] screen à [ SCOPE ] screen à
à [ SCOPE+AF-FFT ] screen à
à [ SCOPE MEMORY ] screen à
2. Press the [ p ] / [ q ] / [  ] / [  ] buttons to recall the
memorized screen you wish.
[ p ] / [  ] button: Recalls the memory towards
the new memory.
1 2 3
à à
[  ] / [ q ] button: Recalls the memory towards
the old memory.
10 9 8
à à
3. To close the scope screen, press the [ SCOPE ]
button several times until the desired screen
appears.
FT 3000 O
DX peraTing
c
Scope
Menu Mode
130 FIX 1.8MHz SPAN
132 FIX 3.5MHz SPAN
134 FIX 5.0MHz SPAN
136 FIX 7.0MHz SPAN
138 FIX 10MHz SPAN
140 FIX 14MHz SPAN
142 FIX 18MHz SPAN
144 FIX 21MHz SPAN
146 FIX 24MHz SPAN
148 FIX 28MHz SPAN
150 FIX 50MHz SPAN
Memorizing the Scope Screen
4 ...... 9 2 ...
10 1
à à à à
7 ...... 2 9 ...
1 10
à à à à
M
anual
Onvenience
Receiving Frequency
Frequency set in Menu Mode
Press the [ SCOPE ] button to display the AF-FFT screen.
[ SCOPE ] button
[p/q//] Button
Erasing the memorized screens
1. Recall the scope screen that you wish to erase us-
ing the [ p ] / [ q ] / [  ] / [  ] button.
2. Press and hold one of the [ p ] / [ q ] / [  ] / [  ] but-
ton for one second to erase the scope screen.
The memory channel is deleted, and the channel
numbers, for channels with higher numbers, are
decremented.
F
eaTures
Sending Frequency
Example of display in split operation
AF-FFT
AF-FFT Screen
(waterfall display)
[ SELECT ] button
Page 41