Antenna Considerations; About Coaxial Cable - Yaesu FT DX 3000 Operating Manual

i
nsTallaTiOn anD
The FT 3000 is designed for use with any antenna system providing a 50 Ohm resistive impedance at the desired op-
DX
erating frequency. While minor excursions from the 50-Ohm specification are of no consequence, if the Standing Wave
Ratio (SWR) present at the Antenna jack is greater than 3:1, the transceiver's Automatic Antenna Tuner may not be able
to reduce the impedance mismatch to an acceptable value.
Every effort should be made to ensure that the impedance of the antenna system be as close as possible to the specified
50-Ohm value. Note that the "G5RV" type antenna does not provide a 50-Ohm impedance on all HF Amateur bands. An
external wide-range antenna coupler must be used with this antenna type.
Any antenna to be used with the FT
when using a "balanced" antenna such as a dipole, remember that a balun or other matching/balancing device must be
used to ensure proper antenna performance.
The same precautions apply to any additional (receive-only) antennas connected to the antenna jacks. if your receive-
only antennas do not have impedance near 50 Ohms at the operating frequency, you may need to install an external an-
tenna tuner to obtain optimum performance.
Use high-quality 50-Ohm coaxial cable for the lead-in to your FT
ficient antenna system will be wasted if poor quality, lossy coaxial cable is used. This transceiver utilizes standard "M"
("PL-259") type connectors.
Page 8
i
nTercOnnecTiOns
A c
ntennA onSiderAtionS
3000 must be fed from the transceiver with 50 Ohm coaxial cable. Therefore,
DX
A c
bout oAxiAl
t pl-259 i
ypicAl nStAllAtion
c
Able
3000 transceiver. All efforts at providing an ef-
DX
F T 30 00 O
DX
M
peraTing anual