Yaesu FT DX 3000 Operating Manual page 20

F p
rOnT anel
[ MIC/SPEED ] Knob
MIC
This knob adjusts the microphone input level for
(non-processed) SSB transmission.
The display will show the relative microphone gain
level for 3 seconds whenever this knob is turned.
A :
dvice
Adjust the [ MIC/SPEED ] knob while speaking in a
somewhat louder than normal voice level, watch the
ALC level and adjust the [ MIC/SPEED ] knob so
that the ALC level indication just reaches the right
edge of the ALC scale. Then, when you speak in
your normal voice level, you will not be over-driving
the microphone amplifier stages.
SPEED
This knob adjusts the keying speed of the internal
CW keyer (4 ~ 60 WPM). Clockwise rotation in-
creases the sending speed.
The display will show the keying speed for 3 sec-
onds whenever this knob is turned.
Page 18
C
OnTrOls
& s
wiTChes
[ PROC/CAR ] Knob
PROC
This knob adjusts the compression (input) level
of the transmitter RF speech processor in the SSB
mode.
CAR
This knob adjusts the RF Power (Carrier) output of
the transceiver. For the SSB mode, set the desired
maximum RF Power output via Menu item "177 TX
MAX POWER" (see page 63).
i N :
mportANt ote
The setting value of Menu item
POWER" is applied to all emission modes.
For example: When Menu item
POWER" is set to "50", the maximum RF Power
output for all emission modes is "50", even if the
[ PROC/CAR ]
knob is set to the fully clockwise po-
sition.
A :
dvice
The RF Power output setting will be shown for 3
seconds in the right of the TFT display whenever the
[ PROC/CAR ]
outer knob is turned, except when
MENU "177 TX MAX
POWER" is set to 5 watts.
[ PROC ]
In the SSB mode the
instead of the RF Power output.
F T 30 00 O
DX
"177 TX MAX
"177 TX MAX
value will be shown
M
peraTing anual