Yaesu FT DX 3000 Operating Manual page 89

c
OnTesT
T m p
eXT essAge rOgrAmming
1. Press the [ MODE ] button to set the operating mode
to CW.
Be sure that Break-in is "Off" by pressing the [ BK-
2.
IN ] button, if necessary.
3. Press the FH-2 [ MEM ] key. A blinking "REC" icon
will appear in the display.
4. Press an FH-2 [ 1 ] ~ [ 5 ] key to select the desired CW
Memory Register into which you wish to program
the text, the blinking "REC" icon will disappear.
5. Use the FH-2 [ t ] and [ u ] keys to set the cursor
position and use the FH-2's [ p ] and [ q ] keys to
choose the letter/number to be programmed in each
slot of the memory. In the case of the second ex-
ample above, the "#" character designates the slot
where the Contest Number will appear.
A :
dvice
You may also use the Main Tuning Dial knob and
the [ CLAR/VFO-B ] knobs to program the message
characters.
FT 3000 O
DX peraTing
cW c
m k
eyer ( U
emOry
M
anual
Onvenience
Fh-2 r
sing The emOTe
6. When the message is complete, add the "}" character
at the end to signify the termination of the message.
7. Press and hold in the FH-2 [ MEM ] key for one sec-
ond to exit, once all characters (including "}") have
been programmed.
c cw m
hecking The
1. Be sure that Break-in is still turned "Off" by the
[ BK-IN ] key.
2. Press the [ MONI ] button to enable the CW monitor.
3. Press an FH-2 [ 1 ] ~ [ 5 ] key, whichever memory you
just recorded in. You will hear the results in the sid-
etone, but no RF energy will be transmitted.
O -T -A cw m
n he ir essAge
1. Press the [ BK-IN ] button to enable transmission. Ei-
ther Full-break-in or Semi-break-in will be engaged,
depending on the setting of Menu item "061 CW
BK-IN".
2. Press an FH-2 [ 1 ] ~ [ 5 ] key, depending on which
CW Memory Register message you wish to transmit.
The programmed message will be transmitted on the
air.
F
eaTureS
)
c k
OnTrOl eypAd
c
emOry OnTenTs
p
lAybAck
Page 87