Using The Speech Processor - Yaesu FT DX 3000 Operating Manual

e
nhancing
U
The FT 3000 Speech Processor is designed to increase "talk power" by increasing the average power output (via a so-
DX
phisticated compression technique) and adjusting the audio quality to the menu settings ("166 P-PRMTRC EQ1 FREQ",
"169 P-PRMTRC EQ2 FREQ", "172 P-PRMTRC EQ3 FREQ"). The result is improved intelligibility when conditions
are difficult.
the [ MIC/SPEED ] knob, as described on
1. Adjust
page 62.
2. Press the [ p/q/t/u ] button to select the "METER",
the [ SELECT ] button to select "COMP"
then press
(Compression) meter.
3. Press the [ p/q/t/u ] button to select the "PROC",
then press the [ SELECT ]
The "PROC" will appear in the display, confirming
that the Speech Processor is engaged.
4. Press the PTT switch on the microphone, and speak
into the microphone in a normal voice level.
5. Adjust the [ PROC/CAR ] knob to set the compres-
sion level within the 5 dB to 10 dB range.
5 ~10dB
6. To switch the Speech Processor off, press the [ SE-
LECT ] button once more. The "PROC" will turn
off, confirming that the Speech processor is turned
off.
A :
dvice
 You may set the RF power output via the Menu item
"177 TX MAX PWR", whether or not the Speech
Processor is engaged.
 You may adjust the Parametric Microphone Equal-
izer when the speech processor is engaged, using
Menu Items "168" through "176". See page 125
for details.
Page 68
T
ranSMiT
s
sing The peech
button to select "ON".
S Q
ignal
( ssb m
p
rOcessOr
[ MIC/SPEED ] Knob
FT
DX
ualiTy
)
Ode
[ SELECT ] Button
[ ] Button
p/q/t/u
3000 O M
peraTing anual