Optional Dvs-2 Digital Voice Recorder - Yaesu FT-1000MP Operating Manual

Operation
Optional DVS-2 Digital Voice Recorder
QD @ @
'
( :
YAE su = ie MODE ®
LAGER = a
DVS-2
Bs77°
ee
CS++@
-—)
C®S7-®
Overview
The DVS-2 is a digital voice recorder designed
especially for SSB, AM, and FM operation with
newer model Yaesu transceivers having a special
jack for connection of the DVS-2 on the rear panel.
It offers two independent functions:
e recording received signals for playback later
in the loudspeaker or headphone,
e recording signals by the microphone for
playback over the air (during transmission).
Each mode uses its own memory, so both
modes can be used to retain data at the same
time. Operating details are provided with the DVS-
2, but a summary is provided here.
Installation
Connect the DVS-2 cable to the Dvs-2 jack on
the rear of the transceiver. pvs-2
You must also have a micro- WOieEaUT
phone connected to the MIC) 4. on,
jack on the front panel of the on
transceiver to record your Xe oY
voice for transmissions. on
as viewed from rear panel
DVS-2 Controls
(1), (2), & (3): PLAY, REC & TX LEDs
These LEDs light or flash to indicate the status
of the DVS-2. The PLAY LED glows green when
playing back stored data, the REC LED glows
yellow when recording, and the TX LED glows red
when the DVS-2 is keying the transmitter to play
back over the air. Also, the PLAY and REC LEDs
flash when waiting for you to make a memory
selection (with a numbered button).
(4) MESSAGE MODE Slide Switch
This selects the mode for recording messages
to be played back over the air: for either two
8-second messages, or four 4-second messages.
Changing your selection does not erase pre-
viously stored messages, so you can use this
switch to combine two pairs of 4-second mes-
sages.
(5) MESSAGE NR Selection Buttons & LEDs
These buttons select which message slot to re-
cord via the microphone or play back over the air.
The LED above each button glows red when a
message has been stored in that slot. The 3 and
4 keys (and LEDs) are only functional when the
MESSAGE MODE switch is set to the 4 x 4 SEC
position.
(6) MONI Button
After recording a message via the microphone,
press this button (followed by a message number
button) to play back that message in the loud-
speaker (instead of over the air).
(7) MEMO Button
Press this button (followed by a message
number button) to record a message via the mi-
crophone.
(8) PLAY Button
After recording received signals, press this but-
ton to play them back in the transceiver's loud-
speaker.
(9) REC Button
Press this button to start the receiver recorder.
The recorder will run continuously (recording an
16-second loop) until you press the STOP button.
(10) STOP Button
Press this button to stop any recording or play-
back operation.
page 65