Engine Removal - KYMCO Grand Dink 250 Service Manual

5
. ENGINE REMOVAL/INSTALLATION GRAND DINK 250
Wire Connectors

ENGINE REMOVAL

Disconnect the battery negative cable.
Remove the frame body cover. ( 2-3)
Disconnect the engine negative cable.
Disconnect all of the A.C. generator, auto
bystarter, spark plug, thermosensor wire
couplers and connectors.
Disconnect the engine fuel tube.
Drain the coolant. ( 3-9)
Disconnect the water hose.
Rear Brake Caliper
Starter Relay
Disconnect the starter motor wire that goes to
the starter relay.
Throttle Cable
Fuel Pump Vacuum Tube
Disconnect the fuel tube and vacuum tube
that go to the carburetor from the fuel pump.
Disconnect the vacuum tube from the air cut-
off valve (ACV).
Disconnect the throttle cable from the
carburetor.
Intake Manifold Band
Brake Fluid Tube
Remove the brake fluid tube bolt of the rear
brake caliper.
Remove the rear brake caliper bolt and the
rear brake caliper.
Rear Brake Caliper
5-2