Scanning A Rfid Code For A New Dictation - Grundig Digta 4015 DS Manual

RFID READER DIGTARFID 414

Scanning a RFID code for a new dictation

SCAN ESC
0350144007000
80398
SCAN OK ESC
No RFID
found
OK
The RFID Reader is connected to the portable dictation machi-
ne and activated.
• Switch on the dictation machine.
• Push the slide switch to »
• Press the »New« button.
– »SCAN« and »ESC« appear in the display.
• If you do not want to scan a RFID code into the dictation
accompanying note, press the »ESC« button and continue
with your dictation as usual.
• If you wish to scan a RFID code, hold the RFID Reader
directly at the label with the RFID code (see illustration)
and press the »SCAN« button.
– The device will now scan the RFID code. If the RFID code
was successfully scanned, the device will acknowledge
this by emitting a single tone.
– The RFID code appears in the display.
• If you want to include the RFID code as displayed in the
dictation, press the »OK« button.
• If you want to re-scan the RFID code, press the »SCAN«
button.
• If you do not want to include the RFID code in the dicta-
tion, press the »ESC« button and continue with your dicta-
tion as usual.
Note:
If the machine cannot read the RFID code, it emits a
double signal tone, and the message »No RFID found«
appears in the display. Confirm the error message with
»OK«. You can now repeat the scan with the »SCAN« but-
ton or cancel it with the »ESC« button and dictate without
a RFID code.
______________
STOP«.
75