Scanning A Barcode For A New Dictation - Grundig Digta 4015 DS Manual

DIGTASCAN 404 BARCODE READER

Scanning a barcode for a new dictation

SCAN ESC
0350144007000
80398
SCAN OK ESC
The DigtaScan must be connected to the portable dictation
machine, enabled and configured for the barcodes you are
using.
• Switch on the dictation machine.
• Push the slide switch to »
• Press the »New« button.
– »SCAN« and »ESC« appear in the display.
• If you do not want to scan a barcode into the dictation
accompanying note, press the »ESC« button and continue
with your dictation as usual.
• If you want to scan a barcode, point the barcode reader
at the barcode as pictured and press the »SCAN« button.
– The device now scans the code with a red laser beam.
The machine acknowledges the successful reading of the
code with a single signal tone, and the laser beam shuts
off.
– The scanned barcode appears in the display.
• If you want to include the barcode as displayed in the
dictation, press the »OK« button.
• If you want to re-scan the code, press the »SCAN« button.
• If you do not want to include the barcode in the dictation,
press the »ESC« button and continue with your dictation as
usual.
STOP«.
_____
64