Scanning A Rfid Code For A New Dictation - Grundig DIGTA 420 User Manual

RFID READER DIGTA RFID 414

Scanning a RFID code for a new dictation

The RFID Reader is connected to the portable dictation
machine and activated.
• Switch on the dictation machine.
• Push the slide switch to »
• Press the »new« button.
– » « and »
• If you do not want to scan a RFID code into the dic-
tation accompanying note, press the »
continue with your dictation as usual.
• If you wish to scan a RFID code, hold the RFID Reader
directly at the label with the RFID code (see illustration)
and press the » « button.
– The device will now scan the RFID code. If the RFID
code was successfully scanned, the device will ack-
nowledge this by emitting a single tone.
– The RFID code appears in the display.
• If you want to include the RFID code as displayed in the
dictation, press the » « button.
• If you do not want to include the RFID code in the dic-
tation, press the »
dictation as usual.
Note:
If the machine cannot read the RFID code, it emits a
double signal tone, and the message »Scan fails
Repeat ?« appears in the display. You can now repeat
the scan with the »
button and dictate without a RFID code.
STOP
« appear in the display.
« button and continue with your
« button or cancel it with the »
_____________
«.
« button and
«
104