Printer Jet Test - Sekonic SR-3500 Operating Manual

Printer jet test

This test is done when the printing of sheets is not possible, is not clear. ( This test will be
conducted only when stacker unit and printer unit are installed. )
1.
MENU
Press the
2.
UP
Use the and
and press the
3.
UP
Use the and
4.
FEED/ENTER
Press the
(" " mark fl ashes in the fi rst column of the fi rst line on the LCD.)
5.
FEED/ENTER
Press the
(When Printer jet test ends , the fl ashing " " mark disappears from the LCD.)
6.
Keep pressing the
or press the
Note)
You cannot return to normal mode while the test is running.
switch to enter the menu mode.
DOWN
switches to select the following parameters,
FEED/ENTER
switch.
DOWN
switches to select [Printer Jet Test].
switch to confi rm the selection and display [PJet Test Start = Start].
switch to do Printer jet test one time.(about 2.5 sec.)
CLEAR/EXIT
switch until it returns to normal mode,
MENU
switch to return to normal mode.
Operating tests Printer jet test
-73-