Sekonic SR-3500 Operating Manual page 115

Error displays and countermeasures
(3) Operation errors
Hopper stops
Drawing out error
Timeout
Timing mark error
Setting error
Black level error
Reading start detection
sensor soiling error
-114-
Error Explanation
Interlock on the side of the
paper-feeding roller operated.
Sheet was pulled out after it
was fed.
A sheet wasn't fed within the
set sheet insertion duration.
Only three or fewer timing
marks were detected on the
front side of the read sheet.
Only three or fewer timing
marks were detected on the
back side of the read sheet.
When reading front side marks
using a timing control type, the
next timing mark is detected
within the are a s e t b y the
control multiple number.
When reading back side marks
using a timing control type, the
next timing mark is detected
within the are a s e t b y the
control multiple number.
There is light colored stain on
the front side reading unit.
There is light colored stain on
the back side reading unit.
There is stain on reading start
detection sensor.
Code Solution
• Release the interlock switch.
• Press the CLEAR switch
R1
( o r e x e c u t e t h e c l e a r e r r o r
command).
Press the CLEAR switch
R2
(or execute the clear error command).
Press the CLEAR switch
R3
(or execute the clear error command).
• Check the direction of the sheet .
• Press the CLEAR switch
R4
( o r e x e c u t e t h e c l e a r e r r o r
command).
• Set a reading type and a control
multiple number according to
paper specifications.
R5
• Press the CLEAR switch
( o r e x e c u t e t h e c l e a r e r r o r
command).
Press the CLEAR switch
S2
(or execute the clear error command).
After cleaning the sensor section
S3
turn the power switch on again.