Printer Settings; Printer Control - Sekonic SR-3500 Operating Manual

Printer settings

A character is 12 x 9 pixels.
Though character height is fi xed (about 3mm), widths can
vary.
However, the number of pixels (9 pixels) does not change,
so if you enlarge a character, the space between pixels
increases, making the character appear lighter.
Printer settings differ depending on the operating mode.

Printer control

You can set the device to either use the printer or not use it.
If you do not use the pinter function,set the invalid.
1.
MENU
Press the
2. UP
Use the and
and press the
3.
UP
Use the and
and press the
(" " mark fl ashes in the fi rst column of the fi rst line on the LCD.)
4.
UP
Use the and
5.
FEED/ENTER
Press the
(The fl ashing " " mark disappears from the LCD.)
6.
Keep pressing the
or press the
(when stacker unit or printer unit are installed)
switch to enter the menu mode.
DOWN
switches to select the following parameters,
FEED/ENTER
switch.
DOWN
switches to select [Printer Control] setting,
FEED/ENTER
switch.
DOWN
switches to set the value.
switch to save the setting value into memory.
CLEAR/EXIT
switch until it returns to normal mode,
MENU
switch to return to normal mode.
Printer settings Printer control
9 pixels
Printer control
setting values
• Valid
• Invalid
12 pixels
-53-