Table of Contents
Advertisement
Connecting to a computer
Connecting to a computer
This device is equipped with USB and RS-232C interfaces.When connecting the OMR,the
connection with USB in order to show the performance of this device sufficiently is
recommended. When connecting using USB, use the USB driver inside CR-ROM that came
with this device.
When replacing the OMR SR-600,SR-9000 series with this device, you can use the RS-232C
interface.
1
When using the RS-232C interface, set the same communication setting on this device and
the computer.
Set the computer communication setting by checking your computer or software manuals.
1 ) There are times when it does not operate normally due to the environment of use.
See the following pages to set the communication setting for this device.
USB
Interface setting (device ID setting) ............................... P.32
• See P.31 and later when using USB.
RS-232C
Setting baud rate ..................................................... P.34
Setting cheracter bit length ...................................... P.34
Setting parity ............................................................ P.35
Setting stop bit ......................................................... P.36
Setting fl ow control .................................................. P.36
Setting character code ............................................. P.37
• See P.33 and later when using RS-232C.
* SR-700 series can operate in SR-600 mode.
Note)
Responding time to resetting command(CAN command) which is
stated in the operating manual of SR-600, SR-9000 series
Time after this device receiving resetting command(CAN command) ,it
return ACK code is maximum approximately 5.6 seconds.
As for the details of commands of SR-600 mode please see the
operating manual of SR-600
As for the details of commands of SR-9000 mode please see the
operating manual of SR-9000
-30-
(
SR-3500
(
Hide quick links:
Advertisement
Chapters
Table of Contents
