Operating Tests; Feed Test 1 - Sekonic SR-3500 Operating Manual

Operating tests

Feed test 1

Operating tests
This section explains operating test procedures.
Feed test 1
This test reads the check sheets included in the package to test if the device reads them
properly.
If the device doesn't read the check sheets properly, the reading test will stop.
Once reading of the check sheets starts, the test will continue until an error occurs or the
hopper is empty.
1.
MENU
Press the
2.
UP
Use the and
and press the
3.
UP
Use the and
4.
FEED/ENTER
Press the
(" " mark fl ashes in the fi rst column of the fi rst line on the LCD.)
5.
UP
Use the and
6.
FEED/ENTER
Press the
(The fl ashing " " mark disappears from the LCD, and the test will start/stop.)
7.
Keep pressing the
or press the
Note)
• You cannot return to normal mode while the test is running.
• If a reading error occurs on both sides of a sheet, the error count will
be two.
• If the stacker unit is installed and an error occurs, paper will be
transfered to the selection tray.
-70-
switch to enter the menu mode.
DOWN
switches to select the following parameters,
FEED/ENTER
switch.
DOWN
switches to select [Feed Test 1].
switch to confi rm the selection and display [Feed Test 1].
DOWN
switches to select the setting value.
switch to start/stop feed test 1.
CLEAR/EXIT
switch until it returns to normal mode,
MENU
switch to return to normal mode.
Feed test 1 setting values
• Stop • Start