Operating Tests; B Feed Test 1 - Sekonic SR-2300 Manual

Operating tests

This section explains operating test procedures.
B
Feed test 1
This test reads the check sheets that came with this product to test if the device reads them
properly.
If the device doesn't read the check sheets properly, the reading test will stop.
Once reading of the check sheets starts, the test will continue until an error occurs or the hopper
is empty.
1.
MENU
Press the
2.
UP
Use the
and press the
3.
UP
Use the
4.
FEED/ENTER
Press the
(" " mark flashes in the first column of the first line on the LCD.)
5.
UP
Use the
6.
FEED/ENTER
Press the
(The flashing " " mark disappears from the LCD, and the test will start/stop.)
7.
Keep pressing the
or press the
Note)
You cannot return to normal mode while the test is running.
switch to enter the menu mode.
DOWN
and switches to select the following parameters,
FEED/ENTER
switch.
DOWN
and switches to select [Feed Test 1].
switch to confirm the selection and display [Feed Test 1].
DOWN
and switches to select the setting value.
switch to start/stop feed test 1.
CLEAR/EXIT
switch until it returns to normal mode,
C
MENU
switch to return to normal mode.
B
Operation tests Feed test 1
Feed test 1 setting values
• Stop • Start
-45-