Rotary And Dip Switch Settings; Accessing The Rotary And Dip Switches; Rotary Switch Rsw1 Settings - Sekonic SR-1800 Operating Manual

Rotary and DIP Switch Settings
The device is shipped from the factory with default settings. Configure the number of lines to
read and device function settings according to its intended use.
If the RS-232C port is used, configure the communication speed and data format settings.
Accessing the Rotary and DIP Switches
1
(1) Remove the stacker from the main body unit.
(2) Bend and remove the DIP switch cover on the bottom left of the stacker side.
(Reattach it after set up is complete.)
RSW1 RSW1
Rotary Switch RSW1 Settings
2
Set the communication speed of the RS-232C port.
CAUTION
· Be careful when configuring settings. Communication errors will occur if settings are
incorrect.
· Make sure the power is off when configuring settings.
: Indicates the factory settings.
SW No. Baud rate [bps]
0 9,600
1 19,200
2 38,400
3 57,600
4 115,200
5 to 9 (Not used)
SW1 SW1 SW2 SW2 SW3 SW3 RSW2 RSW2
DIP switch cover DIP switch cover
SR-1800