Adding A User Directly To Cisco Unified Communications Manager; Configuring The Phone - Cisco IP Phone Administration Manual

Appendix E Basic Phone Administration Steps

Adding a User Directly to Cisco Unified Communications Manager

If you are not using an LDAP directory, you can add a user directly to Cisco Unified Communications
Manager Administration by following these steps:
Procedure
Choose User Management > End User, then click Add New. The End User Configuration window
Step 1
appears.
In the User Information pane of this window, enter the following:
Step 2
Click Save.
Step 3
Proceed to the section
Step 4

Configuring the Phone

First, perform the following procedure to identify the user's phone model and protocol:
Procedure
From Cisco Unified Communications Manager administration, choose Device > Phone.
Step 1
Click Add New.
Step 2
Step 3 Select the user's phone model from the Phone Type drop-down list, then click Next.
Select the device protocol (SCCP or SIP) from the drop-down list, then click Next. The Phone
Step 4
Configuration window appears.
On the Phone Configuration window, you can use the default values for most of the fields.
To configure the required fields and some key additional fields, follow these steps:
OL-23091-01
User ID—Enter the end user identification name. Cisco Unified Communications Manager does
–
not permit modifying the user ID after it is created. You may use the following special
characters: =, +, <, >, #, ;, \, , "", and blank spaces.
Example: johndoe
Password and Confirm Password—Enter five or more alphanumeric or special characters for the
–
end user password. You may use the following special characters: =, +, <, >, #, ;, \, , "", and
blank spaces.
– Last Name—Enter the end user last name. You may use the following special characters: =, +,
<, >, #, ;, \, , "", and blank spaces.
Example: doe
Telephone Number—Enter the primary directory number for the end user. End users can have
–
multiple lines on their phones.
Example: 26640 (John Doe's internal company telephone number)
Configuring the Phone, page
Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)
E-3.
Configuring the Phone
E-3