Adding A User To Cisco Unified Communications Manager; Adding A User From An External Ldap Directory; Adding A User Directly To Cisco Unified Communications Manager - Cisco CP-7942G Software Manual

Adding a User to Cisco Unified Communications Manager

Adding a User to Cisco Unified Communications Manager
This section describes steps for adding a user to Cisco Unified Communications Manager. Follow one
of the procedures in this section, depending on your operating system and the manner in which you are
adding the user:
•
•

Adding a User From an External LDAP Directory

If you added a user to an LDAP Directory (a non-Cisco Unified Communications Server directory), you
can immediately synchronize that directory to the Cisco Unified Communications Manager on which
you are adding this same user and the user's phone by following these steps:
Procedure
Log onto Cisco Unified Communications Manager Administration.
Step 1
Choose System > LDAP > LDAP Directory.
Step 2
Step 3 Use the Find button to locate your LDAP directory.
Step 4 Click on the LDAP directory name.
Step 5 Click Perform Full Sync Now.
Note
Proceed to
Step 6

Adding a User Directly to Cisco Unified Communications Manager

If you are not using an LDAP directory, you can add a user directly to Cisco Unified Communications
Manager Administration by following these steps:
Procedure
Choose User Management > End User, then click Add New. The End User Configuration window
Step 1
appears.
In the User Information pane of this window, enter the following:
Step 2
Cisco Unified IP Phone 7962G and 7942G Administration Guide for Cisco Unified Communications Manager 7.0
E-2
Adding a User From an External LDAP Directory, page E-2
Adding a User Directly to Cisco Unified Communications Manager, page E-2
If you do not need to immediately synchronize the LDAP Directory to the Cisco Unified
Communications Manager, the LDAP Directory Synchronization Schedule on the LDAP
Directory window determines when the next auto-synchronization is scheduled. However, the
synchronization must occur before you can associate a new user to a device.
Configuring the Phone, page
User ID—Enter the end user identification name. Cisco Unified Communications Manager does
–
not permit modifying the user ID after it is created. You may use the following special
characters: =, +, <, >, #, ;, \, , "", and blank spaces.
Appendix E
E-3.
Basic Phone Administration Steps
OL-15483-01