Parameter Clear - Mitsubishi Electric FR-F700 Series Instruction Manual

Parameter clear

4.7 Parameter clear
POINT
· Set "1" in Pr.CL parameter clear to initialize all parameters. (Parameters are not cleared when "1" is set in Pr. 77
Parameter write selection. In addition, calibration parameters are not cleared.)
· Refer to the extended parameter list on page 102 for parameters to be cleared with this operation.
1.
Screen at powering on
The monitor display appears.
2.
Press
mode.
3.
Press
setting mode.
4.
Turn until "
appears.
5.
Press
" "(initial value) appears.
6.
Turn clockwise to change it to
the setting value of " ".
7.
Press
and
The inverter is not in the PU operation mode.
1. Press
2. Carry out operation from step 6 again.
58
Operation
to choose the PU operation
to choose the parameter
" (parameter clear)
to read the currently set value.
to set.
· Turn to read another parameter.
· Press to show the setting again.
· Press twice to show the next parameter.
are displayed alternately ... Why?
.
is lit and the monitor (4 digit LED) displays "0" (Pr.79 = "0" (initial value)).
Display
PU indication is lit.
Flicker ··· Parameter setting complete!!
The parameter
number read
previously appears.