Mitsubishi Electric FR-F700 Series Instruction Manual page 10

FR-F720-01540-NA or more, FR-F740-00770-NA or more
•
Removal
1) Remove installation screws on
the front cover 1 to remove the
front cover 1. (For the FR-F740-
03250 and 03610, six positions
are fixed with screws.)
Front cover 1
•
Reinstallation
1) Insert the two fixed hooks on the left side of the
front cover 2 into the sockets of the inverter.
CAUTION
1. Fully make sure that the front cover has been reinstalled securely. Always tighten the installation screws of the front cover.
2. The same serial number is printed on the capacity plate of the front cover and the rating plate of the inverter. Before
reinstalling the front cover, check the serial numbers to ensure that the cover removed is reinstalled to the inverter from
where it was removed.
2) Loosen the installation
screws of the front cover 2.
Front cover 2
Front cover 2
3) Fix the front cover 2 with the
installation screws.
Front cover 2
Method of removal and reinstallation of the
3) Pull the front cover 2 toward you to
remove by pushing an installation
hook on the right side using left
fixed hooks as supports.
2) Using the fixed hooks as supports, securely
press the front cover 2 against the inverter.
(Although installation can be done with the
operation panel mounted, make sure that a
connector is securely fixed.)
Front cover 2
4) Fix the front cover 1 with the
installation screws. (For the FR-F740-
03250 and 03610, fix six positions with
screws.)
front cover
Installation hook
Front cover 1
5
2