Mitsubishi Electric FR-F700 Series Instruction Manual page 48

Operation
9.
While the value is flickering,
press to set the frequency.
If you do not press
for about 5s and the display then returns
to 0.00 (display) Hz. At this time, return to
"Step 3" and set the frequency again.
10.
Turn the start switch (STF or STR) off.
The motor decelerates according to
Pr. 8 Deceleration time to stop.
REMARKS
· Pr. 178 STF terminal function selection must be set to "60" (or Pr. 179 STR terminal function selection must be set to "61").
(all are initial values)
· When Pr. 79 Operation mode selection is set to "3", multi-speed operation (refer to page 44) is also made valid.
When the inverter is stopped by
are displayed alternately.
1. Turn the start switch (STF or STR) off.
2. The display can be reset by
Flicker ··· Frequency setting complete!!
,the value flickers
Forward
rotation Reverse
rotation
OFF
of the operation panel (FR-DU07),
.
Operation by the start command of the
terminal block (external operation)
Display
Stop
and
Flickering
3
43